Service Manual

Version Description
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 Introduced on the E-Series.
Usage Information Messages can contain an unlimited number of lines; however, each line is limited to 255 characters. To move to the
next line, use <CR>. To send the message use CTR-Z; to abort a message, use CTR-C.
service timestamps
To debug and log messages, add time stamps. This command adds either the uptime or the current time and date.
Syntax
service timestamps {debug | log} [datetime [localtime] [msec] [show-timezone] |
uptime]
To disable timestamping, use the no service timestamps [debug | log] command.
Parameters
debug (OPTIONAL) Enter the keyword debug to add timestamps to debug messages.
log (OPTIONAL) Enter the keyword log to add timestamps to log messages with severity
from 0 to 6.
datetime (OPTIONAL) Enter the keyword datetime to have the current time and date added to
the message.
localtime (OPTIONAL) Enter the keyword localtime to include the localtime in the timestamp.
msec (OPTIONAL) Enter the keyword msec to include milliseconds in the timestamp.
show-timezone (OPTIONAL) Enter the keyword show-timezone to include the time zone information
in the timestamp.
uptime (OPTIONAL) Enter the keyword uptime to have the timestamp based on time elapsed
since system reboot.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
Control and Monitoring 125