Service Manual
rate-police
Specify the policing functionality on incoming trac.
S4048–ON
Syntax
rate-police [kbps] committed-rate [burst-KB] [peak [kbps] peak-rate [burst-KB]]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits per second (Kbps). Make the
following value a multiple of 64. The range is from 0 to 40000000. The default granularity
is Megabits per second (Mbps).
committed-rate Enter the bandwidth in Mbps. The range is from 0 to 40000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 16 to 200000. The default is
100.
peak peak-rate (OPTIONAL) Enter the keyword peak then a number to specify the peak rate in Mbps.
The range is from 0 to 40000. The default is the same as designated for committed-
rate
.
Defaults Burst size is 100KB. peak-rate is by default the same as committed-rate. Granularity for committed-
rate and peak-rate is Mbps unless you use the kbps option.
Command Modes QOS-POLICY-IN
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage Information The default burst size is 100Kb. If a dierent value is required, you must congure the burst size to the required
value.
1290 Quality of Service (QoS)