Service Manual
ip split-horizon
Enable split-horizon for RIP data on the interface. As described in RFC 2453, the split-horizon scheme prevents any routes learned over a
specic interface to be sent back out that interface.
S4048–ON
Syntax
ip split-horizon
To disable split-horizon, use the no ip split-horizon command.
Defaults Enabled
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Related Commands
• ip poison-reverse — sets the prex for RIP routing updates.
maximum-paths
Set RIP to forward packets over multiple paths.
S4048–ON
Syntax
maximum-paths number
To return to the default values, use the no maximum-paths commands.
1330 Routing Information Protocol (RIP)