Service Manual

ssh-peer-stack-unit
Open an SSH connection to the peer stack-unit.
Syntax
ssh-peer-stack-unit [-l username]
Parameters
-l username (OPTIONAL) Enter the keyword -l then your user name. The default is the user name
associated with the terminal.
Defaults Not congured.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S-Series.
telnet
Connect through Telnet to a server. The Telnet client and server in Dell Networking support IPv4 and IPv6 connections. You can establish a
Telnet session directly to the router or a connection can be initiated from the router.
NOTE
: The Telnet server and client are VRF-aware. Using the vrf parameter in this command, you can make a Telnet server or
client to listen to a specic VRF. This capability enables a Telent server or client to look up the correct routing table and establish
a connection.
Syntax
telnet {host | ip-address | ipv6-address prefix-length | vrf vrf instance name}
[/source-interface]
Parameters
host Enter the name of a server.
ip-address Enter the IPv4 address in dotted decimal format of the server.
ipv6-address prex-
length
Enter the IPv6 address in the x:x:x:x::x format then the prex length in the /x format. The
range is from /0 to /128.
NOTE: The :: notation species successive hexadecimal elds of zeros.
vrf instance (Optional) Enter the keyword vrf then the VRF instance name.
Control and Monitoring 149