Service Manual
storm-control broadcast [percentage decimal_value in | out]| [wred-profile name]]
[packets_per_second in]
To disable broadcast rate-limiting, use the storm-control broadcast [percentage decimal_value in | out] | [wred-
prole name]] [packets_per_second in] command.
Parameters
percentagedecimal
_value in | out
Enter the percentage of broadcast trac allowed in or out of the network. Optionally, you
can designate a decimal value percentage, for example, 55.5%. The decimal range is
from .1 to .9.
wred-prole name Enter the keyword wred-prole followed by the prole name to designate a wred-prole.
packets_per_secon
d in
Enter the packets per second of broadcast trac allowed into the network. The range is
from 0 to 33554368.
Defaults none
Command Modes CONFIGURATION (conf)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-MUX
(PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 E-Series Only: Added the percentage decimal value option.
6.5.1.0 Introduced on the E-Series.
Usage Information Broadcast storm control is valid on Layer 2/Layer 3 interfaces only. Layer 2 broadcast trac is treated as
unknown-unicast trac.
storm-control broadcast (Interface)
Congure the percentage of broadcast trac allowed on an interface (ingress only).
Syntax
storm-control broadcast [packets_per_second in]
Storm Control 1553