Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

1701

Command History

This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking

OS Command Line Reference Guide.

Version Description

9.10(0.0) Introduced on the S6100–ON.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

7.6.1.0 Introduced on the S-Series (S50 only).

7.5.1.0 Introduced on the C-Series.

6.2.1.1 Introduced on the E-Series.

Usage Information

If you disable the interface, the cost value is subtracted from the priority value and forces a new MASTER election

if the priority value is lower than the priority value in the BACKUP virtual routers.

virtual-address

Congure up to 12 virtual router IP addresses in the VRRP group. To start sending VRRP packets, set at least one virtual IP address for the

VRRP group.

Syntax

virtual-address ip-address1 [... ip-address12]

To delete one or more virtual IP addresses, use the no virtual-address ip-address1 [... ip-

address12] command.

Parameters

ip-address1 Enter an IP address of the virtual router in dotted decimal format. The IP address must be

on the same subnet as the interface’s primary IP address.

... ip-address12 (OPTIONAL) Enter up to 11 additional IP addresses of virtual routers in dotted decimal

format. Separate the IP addresses with a space. The IP addresses must be on the same

subnet as the interface’s primary IP address.

Defaults Not congured.

Command Modes VRRP