Service Manual

• CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Example
Dell(config-std-nacl)# show conf
!
ip access-list standard test
remark 5 Permit traffic from XYZ Inc.
seq 5 permit 1.1.1.0/24 count
remark 10 Deny traffic from ABC
seq 10 deny 2.1.1.0/24 count
Dell(config-std-nacl)#
Common IP ACL Commands
The following commands are available within both Ingress and Egress IP ACL modes (Standard and Extended) and do not have mode-
specic options. When an ACL is created without a rule and then is applied to an interface, ACL behavior reects an implicit permit.
The platform supports both Ingress and Egress IP ACLs.
NOTE
: Also refer to the Commands Common to all ACL Types section.
access-class
Apply a standard ACL to a terminal line.
Syntax
access-class access-list-name [ipv4 | ipv6]
To remove an ACL, use the no access-class command.
Parameters
access-list-name Enter the name of a congured Standard ACL, up to 140 characters.
184 Access Control Lists (ACL)