Service Manual

ipv4 Enter the keyword ipv4 to congure an IPv4 access class.
ipv6 Enter the keyword ipv6 to congure an IPv6 access class.
Defaults Not congured.
Command Modes LINE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the ipv4 and ipv6 parameters to the command.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Increase the name string to accept up to 140 characters. Prior to 7.8.1.0, names were up to
16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information
When you use the access-class access-list-name command without specifying the ipv4 or ipv6
attribute, both IPv4 as well as IPv6 rules that are dened in that ACL are applied to the terminal. This method is a
generic way of conguring access restrictions.
To be able to lter access exclusively using either IPv4 or IPv6 rules, use either the ipv4 or ipv6 attribute along
with the
access-class access-list-name command. Depending on the attribute that you specify (ipv4
or ipv6), the ACL processes either IPv4 or IPv6 rules, but not both. Using this conguration, you can set up two
dierent types of access classes with each class processing either IPv4 or IPv6 rules separately.
However, if you already have congured generic IP ACL on a terminal line, then you cannot further apply IPv4 or
IPv6 specic ltering on top of this conguration. Because, both IPv4 and IPv6 access classes are already
congured on this terminal line. Before applying either IPv4 or IPv6 ltering, rst undo the generic conguration
using the no access-class access-list-name command.
Similarly, if you have congured either IPv4 or IPv6 specic ltering on a terminal line, you cannot apply generic IP
ACLs on top of this conguration. Before applying the generic ACL conguration, rst undo the existing
conguration using the no access-class access-list-name [ipv4 | ipv6] command.
Access Control Lists (ACL) 185