Service Manual

Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to
16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series
6.1.1.0 Introduced on the E-Series.
Usage Information The ACL hit counters increment the counters for each matching rule, not just the rst matching rule.
Example
Dell# show mac accounting access-list TestMac interface tengigabitethernet 1/8
in
Ingress Standard mac access-list TestMac on TenGigabitEthernet 1/89
Total cam count 2
seq 5 permit aa:aa:aa:aa:00:00 00:00:00:00:ff:ff count (0 packets)
seq 10 deny any count (20072594 packets)
Dell#
Standard MAC ACL Commands
When you create an access control list without any rule and then apply it to an interface, the ACL behavior reects implicit permit. These
commands congure standard MAC ACLs and support both Ingress and Egress MAC ACLs.
NOTE
: For more information, also refer to the Commands Common to all ACL Types and Common MAC Access List Commands
sections.
deny
To drop packets with a the MAC address specied, congure a lter.
Syntax
deny {any | mac-source-address [mac-source-address-mask]} [count [byte]] [log]
[monitor]
To remove this lter, you have two choices:
220 Access Control Lists (ACL)