Service Manual

count for that new interval commences from zero. If ACL logging was stopped previously because the congured
threshold is exceeded, it is reenabled for this new interval.
If ACL logging is stopped because the congured threshold is exceeded, it is reenabled after the logging interval
period elapses. ACL logging is supported for standard and extended IPv4 ACLs, standard and extended IPv6 ACLs,
and standard and extended MAC ACLs. You can congure ACL logging only on ACLs that are applied to ingress
interfaces; you cannot enable logging for ACLs that are associated with egress interfaces.
You can activate ow-based monitoring for a monitoring session by entering the ow-based enable command in
the Monitor Session mode. When you enable this capability, trac with particular ows that are traversing through
the ingress and egress interfaces are examined and, appropriate ACLs can be applied in both the ingress and
egress direction. Flow-based monitoring conserves bandwidth by monitoring only specied trac instead all trac
on the interface. This feature is particularly useful when looking for malicious trac. It is available for Layer 2 and
Layer 3 ingress and egress trac. You may specify trac using standard or extended access-lists. This mechanism
copies all incoming or outgoing packets on one port and forwards (mirrors) them to another port. The source port
is the monitored port (MD) and the destination port is the monitoring port (MG).
seq (for IP ACLs)
Assign a sequence number to a deny or permit lter in an extended IP access list while creating the lter.
Syntax
seq sequence-number {deny | permit} {ip-protocol-number | icmp | ip | tcp |
udp} {source mask | any | host ip-address} {destination mask | any | host ip-
address} [operator port [port]] [count [byte]] [dscp value] [order] [fragments]
[log [interval minutes] [threshold-in-msgs [count]] [monitor]
Parameters
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate
the maximum number of ACL logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny commands. The threshold
range is from 1 to 100..
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes at
which ACL logs must be generated. The interval range is from 1 to 10 minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the trac that you
want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is ve minutes. By default, ow-based monitoring is not
enabled.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Access Control Lists (ACL) 299