Service Manual

Usage Information
You cannot set this conguration for a peer that is associated with a peer group. Similarly, you cannot associate a
peer to a peer group if that peer is already congured with these settings.
Related Commands
• bgp four-octet-as-support — enable 4-byte support for the BGP process.
neighbor default-originate
Inject the default route to a BGP peer or neighbor.
Syntax
neighbor {ip-address | peer-group-name} default-originate [route-map map-name]
To remove a default route, use the no neighbor {ip-address | peer-group-name} default-
originate command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to set the default route of all routers in that peer group.
route-map map-
name
(OPTIONAL) Enter the keyword route-map then the name of a congured route map.
Defaults Not congured.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information If you apply a route map to a BGP peer or neighbor with the neighbor default-originate command
congured, the software does not apply the set lters in the route map to that BGP peer or neighbor.
When you congure a route-map for a BGP peer or peer group with the neighbor default-originate
command, the command checks for the existence of the route in BGP RIB.
Route-map conguration on a BGP peer or peer group works only when the LOC-RIB contains at least one route.
380 Border Gateway Protocol