Service Manual

neighbor distribute-list
Distribute BGP information via an established prex list.
Syntax
neighbor {ip-address | peer-group-name} distribute-list prefix-list-name {in |
out}
To delete a neighbor distribution list, use the no neighbor {ip-address | peer-group-name}
distribute-list prefix-list-name {in | out} command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to apply the distribute list lter to all routers in the peer
group.
prex-list-name
Enter the name of an established prex list.
If the prex list is not congured, the default is permit (to allow all routes).
in Enter the keyword in to distribute only inbound trac.
out Enter the keyword out to distribute only outbound trac.
Defaults Not congured.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information Other BGP ltering commands include: neighbor filter-list, ip as-path access-list, and
neighbor route-map.
Related Commands
• neighbor route-map — assign a route map to a neighbor or peer group.
382 Border Gateway Protocol