Service Manual

Version Description
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information At least one interface must be in Layer 3 mode for the router bgp command to be accepted. If no interfaces
are enabled for Layer 3, an error message appears:
% Error: No router id
configured
BGP does not allow 23456 (AS-TRANS) as a congured AS number.
Example
Dell(conf)# router bgp 3
Dell(conf-router_bgp)#
set extcommunity bandwidth
Enables you to set extended community bandwidth.
Syntax
set extcommunity bandwidth
To disable extended community bandwidth, enter the no set extcommunity bandwidth command.
Parameters
bandwidth Enter the keyword bandwidth to enable extended community bandwidth. The range is
from 0 to 102400.
Defaults N/A
Command Modes ROUTER MAP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S-Series.
Usage Information
A new policy command is introduced in order to attach the Link Bandwidth extended community only to the
prexes that are received from a neighbor that satisfy the desired conditions. This command is relevant for both
inbound as well as outbound policy handling (for received prexes). Also, there is no change to the set of
supported conditions or lters.
During conguration, the bandwidth is specied in Mbps, not in bytes/second. While creating the actual LB
extended community, the system will attach the AS number and encode the bandwidth in oating point format.
408 Border Gateway Protocol