Service Manual

Parameters
{ets-conf | ets-reco
| pfc}
Enter the PFC and ETS TLVs advertised, where:
ets-conf: enables the advertisement of ETS conguration TLVs.
ets-reco: enables the advertisement of ETS recommend TLVs.
pfc: enables the advertisement of PFC TLVs.
Defaults All PFC and ETS TLVs are advertised.
Command Modes PROTOCOL LLDP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
You can congure the transmission of more than one TLV type at a time; for example: advertise dcbx-tlv
ets-conf ets-reco.
You can enable ETS recommend TLVs (ets-reco) only if you enable ETS conguration TLVs (ets-conf). To
disable TLV transmission, use the no form of the command; for example, no advertise dcbx-tlv pfc
ets-reco
.
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Congure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify the DCBX
conguration on a port, use the show interface dcbx detail command.
dcbx port-role
Congure the DCBX port role the interface uses to exchange DCB information.
Syntax
dcbx port-role {config-source | auto-downstream | auto-upstream | manual}
To remove DCBX port role, use the no dcbx port-role {config-source | auto-downstream |
auto-upstream | manual} command.
Parameters
cong-source |
auto-downstream |
auto-upstream |
manual
Enter the DCBX port role, where:
config-source: congures the port to serve as the conguration source on the
switch.
auto-upstream: congures the port to receive a peer conguration. The
conguration source is elected from auto-upstream ports.
494 Data Center Bridging (DCB)