Service Manual
DHCP Mode
To enable and congure Dynamic Host Conguration Protocol (DHCP), use DHCP mode. For more information, see Dynamic Host
Conguration Protocol (DHCP).
To enter DHCP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2
Enter the ip dhcp server command. The prompt changes to include config-dhcp.
You can return to CONFIGURATION mode by using the exit command.
DHCP POOL Mode
To create an address pool, use DHCP POOL mode. For more information, see Dynamic Host Conguration Protocol (DHCP).
To enter DHCP POOL mode:
1 Verify that you are logged in to DHCP mode.
2 Enter the pool command then the pool name. The prompt changes to include config-dhcp-pool-name.
You can return to DHCP mode by using the exit command.
ECMP GROUP Mode
To enable or congure trac distribution monitoring on an ECMP link bundle, use ECMP GROUP mode. For more information, see
ecmp_overview.
To enter ECMP GROUP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the ecmp-group command then enter the ECMP group ID. The prompt changes to include conf-ecmp-group-ecmp-
group-id
.
You can return to CONFIGURATION mode by using the exit command.
EIS Mode
To enable or congure Egress Interface Selection (EIS), use EIS mode.
To enter EIS mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the management egress-interface-selection command. The prompt changes to include conf-mgmt-eis.
You can return to CONFIGURATION mode by using the exit command.
EXEC Mode
When you initially log in to the switch, by default, you are logged in to EXEC mode. This mode allows you to view settings and enter EXEC
Privilege mode, which is used to congure the device.
50
CLI Basics