Service Manual

dcb-map
Create a DCB map to congure priority ow control (PFC) and enhanced transmission selection (ETS) on Ethernet ports that support
converged Ethernet trac. Apply the DCB map to an Ethernet interface.
Syntax
dcb-map map-name
Parameters
map-name Enter a DCB map name. The maximum number of alphanumeric characters is 32.
Defaults None. There are no pre-congured PFC and ETS settings on S5000 Ethernet interfaces.
Command Modes CONFIGURATION
INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.3(0.0) Introduced on the S4810 and S6000 platforms.
Usage Information
A DCB map is a template used to congure DCB parameters and apply them on converged Ethernet interfaces.
DCB parameters include priority-based ow control (PFC) and enhanced trac selection (ETS).
To display the PFC and ETS settings in DCB maps, enter the show qos dcb-map name command.
Use the dcb-map command to create a DCB map to specify PFC and ETS settings and apply it on Ethernet ports.
After you apply a DCB map to an interface, the PFC and ETS settings in the map are applied when the Ethernet
port is enabled. DCBx is enabled on Ethernet ports by default.
The dcb-map command is supported only on physical Ethernet interfaces.
To remove a DCB map from an interface, enter the no dcb-map map-name command in Interface conguration
mode.
You can enable or disable pfc mode on the DCB mode using the pfc mode on or pfc mode off command.
priority-pgid
Assign 802.1p priority trac to a priority group in a DCB map.
Syntax
priority-pgid dot1p0_group-num dot1p1_group-num dot1p2_group-num dot1p3_group-
num dot1p4_group-num dot1p5_group-num dot1p6_group-num dot1p7_group-num
Parameters
dot1p0–7_group-
num
Enter the priority group number for each 802.1p class of trac in a DCB map.
Defaults None
Data Center Bridging (DCB) 501