Service Manual

Usage Information This command enables a hardware watchdog mechanism that automatically reboots an Dell Networking OS
switch/ router with a single unresponsive unit. This behavior is a last-resort mechanism intended to prevent a
manual power cycle.
show hardware mac
Display MAC ACL entries for the specied stack-unit, port-pipe and pipeline ID.
Syntax
show hardware mac {eg-acl | in-acl} stack-unit id port-set 0–0
Parameters
eg-acl | in-acl Enter either the keyword eg-acl or the keyword in-acl to select between ingress or
egress ACL data.
stack-unit id Enter the keyword stack-unit to select the stack unit ID.
port-set 0–0 Enter the keywords port-set with a port-pipe number to display the MAC ACL entries
for the specied port-pipe number. . The range is from 0 to 0.
Defaults None
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
Usage Information The unit numbers given are internal port numbers.
show hardware ip
Display ACL or QoS data for the selected stack member and stack member port-pipe.
Syntax
show hardware layer3 {acl | qos} stack-unit number port-set 0–0
Parameters
acl | qos Enter either the keyword acl or the keyword qos to select between ACL or QoS data.
stack-unit number Enter the keywords stack-unit then a number to select a stack ID.
port-set 0–0 Enter the keyword port-set with a port-pipe number. The range is from 0 to 0.
524 Debugging and Diagnostics