Service Manual
When you change one or both of the optional parameters, Dell Networking OS checks that the interval between
auto failovers is more than ve (5) minutes. If the interval is less, Dell Networking OS returns a conguration error
message.
redundancy disable-auto-reboot
Prevent the system from auto-rebooting the failed module.
Syntax
redundancy disable-auto-reboot stack-unit [stack—unit ID| members} [rpm| card
number | all]
To return to the default, use the no redundancy disable-auto-reboot stack-unit rpm command.
Parameters
rpm Enter the keyword rpm to disable auto-reboot of the failed RPM.
stack-unit Enter the keyword stack-unit then the stack-unit ID number.
Default Disabled — the failed module is automatically rebooted.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Added the all option.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the E-Series
Usage Information Enabling this command keeps the failed RPM in the failed state. If there are two RPMs in the system, enabling this
command prevents the failed RPM from becoming a working Standby RPM. If there is only one RPM in the
system, the failed RPM does not recover and aects the system.
High Availability (HA) 637