Service Manual

Parameters
access-list
Enter the name of the extended ACL (16 characters maximum).
Defaults Not congured
Command Modes INTERFACE (conf-if-interface-slot/port)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
7.6.1.0 Introduced on E-Series.
Usage Information The access list accepted is an extended ACL. To block IGMP reports from hosts, on a per-interface basis based on
the group address and source address that you specify in the access list, use this feature.
ip igmp immediate-leave
Enable IGMP immediate leave.
Syntax
ip igmp immediate-leave [group-list prefix-list-name]
To disable ip igmp immediate leave, use the no ip igmp immediate-leave command.
Parameters
group-list prex-list-
name
Enter the keywords group-list then a string up to 16 characters long of the prex-list-
name.
Defaults Not congured.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
652 Internet Group Management Protocol (IGMP)