Service Manual

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage Information This command applies to any physical interface with speed set to 10/100.
NOTE: Starting with Dell Networking OS version 7.8.1.0, when you use a copper SFP2 module with
catalog number GP-SFP2-1T in the S25P model of the S-Series, you can manually set its speed with
the speed command. When you set the speed to 10 Mbps or 100 Mbps, you can also execute the
duplex command.
Related Commands
• negotiation auto — enable or disables auto-negotiation on an interface.
owcontrol
Control how the system responds to and generates 802.3x pause frames on 10 Gig ports.
Syntax
flowcontrol rx {off | on} tx {off | on} [negotiate | pause-threshold value |
resume-offset value]
To return to the default, use the no form of this command.
Parameters
rx on Enter the keywords rx on to process the received ow control frames on this port.
rx o Enter the keywords rx off to ignore the received ow control frames on this port.
tx on Enter the keywords tx on to send control frames from this port to the connected device
when a higher rate of trac is received.
tx o Enter the keywords tx off so that ow control frames are not sent from this port to
the connected device when a higher rate of trac is received.
pause-threshold Enter the buer threshold limit for generating PAUSE frames.
resume-oset Enter the oset value for generating PAUSE frames to resume trac.
Defaults
Command Modes INTERFACE
Interfaces 681