Service Manual

interface
Congure a physical or virtual interface on the switch.
Syntax
interface interface
Parameters
interface Enter one of the following keywords and the interface information:
• For a null interface, enter the keyword null then the slot/port information. The Null
interface number is 0.
• For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a Tunnel interface, enter the keyword tunnel then the tunnel ID. The range is
from 1 to 16383.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a port channel interface, enter the keywords port-channel then a number.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added the support for interfaces.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
684 Interfaces