Service Manual

• interface loopback — congure a loopback interface.
• interface null — congure a null interface.
• interface port-channel — congure a port channel group.
• show vlan — display the current VLAN conguration on the switch.
• shutdown — disable/enable the VLAN.
• tagged — add a Layer 2 interface to a VLAN as a tagged interface.
• untagged — add a Layer 2 interface to a VLAN as an untagged interface.
intf-type cr4 autoneg
Set the interface type as CR4 with auto-negotiation enabled. To set the interface type as CR4 with autonegotiation disabled, use the no
intf-type cr4 autoneg command.
Syntax
intf-type cr4 autoneg
Defaults
Not congured
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
You can congure the interface type as CR4 with auto-negotiation enabled. If a DAC cable link is down, you can
resolve the issue by setting the interface type as CR4.
Auto-negotiation is disabled by default. If the CR4 optic fails to come up, use the autoneg option.
Related Commands
• Interfaces — congure a physical interface.
• interface loopback — congure a loopback interface.
• interface null — congure a null interface.
• interface port-channel — congure a port channel group.
Interfaces 695