Service Manual

Version Description
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4093 VLANs on E-Series.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced.
Example
Dell(conf-if-range-te-2/2,fo-2/56)# show range
2/2 - 0
2/56 - 0
Dell(conf-if-range-te-2/2,fo-2/56)#
Related Commands
• interface — congure a physical interface on the switch.
• show ip interface — display Layer 3 information about the interfaces.
• show interfaces — display information on a specic physical interface or virtual interface.
show running-cong ecmp-group
Display interfaces, LAG, or LAG link bundles being monitored for uneven trac distribution using the ecmp-group monitoring
enable
command. The ECMP group could have a LAG or a list of 10G/40 interfaces (not just LAG link-bundles).
Syntax
show running-config ecmp-group
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
Related Commands
• ecmp-group — congure a mechanism to monitor trac distribution.
728 Interfaces