Service Manual

• Routing information protocol (RIP) is not supported with the UDP Broadcast feature.
• If you congure this feature on an interface using the ip udp-helper udp-port command, the ip directed-broadcast
command becomes ineective on that interface.
• The existing show interface command has been modied to display the congured broadcast address.
debug ip udp-helper
Enable UDP debug and display the debug information on a console.
Syntax
debug ip udp-helper
To disable debug information, use the no debug ip udp-helper command.
Defaults Debug disabled.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Pre-version 8.3.7.0 Introduced on the E-Series.
Example
Dell# debug ip udp-helper
UDP helper debugging is on
01:20:22: Pkt rcvd on Gi 3/0 with IP DA (0xffffffff) will be sent on Gi 5/1 Gi
5/2
Vlan 3
01:44:54: Pkt rcvd on Gi 4/0 is handed over for DHCP processing.
Dell# debug ip udp-helper
UDP helper debugging is on
01:20:22: Pkt rcvd on Te 3/0 with IP DA (0xffffffff) will be sent on Gi 5/1 Gi
5/2
Vlan 3
01:44:54: Pkt rcvd on Te 4/0 is handed over for DHCP processing.
Related Commands
• ip udp-helper udp-port — enable the UDP broadcast feature on an interface.
• show ip udp-helper — display the congured UDP helper(s) on all interfaces.
Interfaces 753