Service Manual
Defaults None
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Pre-version 8.3.7.0 Introduced on the E-Series.
Example
Dell# show ip udp-helper
--------------------------------------------------
Port UDP port list
--------------------------------------------------
Te 10/2 656, 658
Te 10/3 All
Related Commands
• debug ip udp-helper — enable debug and displays the debug information on a console.
• ip udp-helper udp-port — enable the UDP broadcast feature on an interface either for all UDP ports or a
specied list of UDP ports.
ip http source-interface
Specify an interface as the source interface for HTTP connections.
Syntax
ip http source-interface interface
To delete an interface, use theno ip http source-interface interface command.
Parameters
interface
Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes CONFIGURATION
Interfaces 755