Service Manual

static (OPTIONAL) Enter the keyword static to view non-active routes also.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Example
Dell# show ip management-route
Destination Gateway State
----------- ------- -----
10.1.2.0/24 ManagementEthernet 1/1 Connected
172.16.1.0/24 10.1.2.4 Active
Dell#
show ipv6 management-route
Display the IPv6 static routes congured for the management interface.
Syntax
show ipv6 management-route [all | connected | summary | static]
Parameters
all (OPTIONAL) Enter the keyword all to view all IP addresses assigned to all Management
interfaces on the switch.
connected (OPTIONAL) Enter the keyword connected to view only routes directly connected to
the Management interface.
summary (OPTIONAL) Enter the keyword summary to view a table listing the number of active
and non-active routes and their sources.
818 IPv4 Routing