Service Manual
show ip trac
View IP, ICMP, UDP, TCP and ARP trac statistics.
Syntax
show ip traffic [all | cp | rp1 | rp2]
NOTE: These options are supported only on the E-Series.
Parameters
all (OPTIONAL) Enter the keyword all to view statistics from all processors. If you do not
enter a keyword, you also view all statistics from all processors.
cp (OPTIONAL) Enter the keyword cp to view only statistics from the Control Processor.
rp1 (OPTIONAL) Enter the keyword rp1 to view only the statistics from Route Processor 1.
rp2 (OPTIONAL) Enter the keyword rp2 to view only the statistics from Route Processor 2.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 F10 Monitoring MIB available for the ip traffic statistics command.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information The following describes the show ip traffic summary shown in the following example.
Keyword Denition
unknown protocol... No receiver for these packets. Counts packets whose protocol type eld is not recognized
by Dell Networking OS.
IPv4 Routing 827