Service Manual

To remove the congured priority bitmap, use the no iscsi priority-bits command.
Defaults 4 (0x10 in the bitmap)
Command Modes PROTOCOL LLDP (only on the global, not on the interface)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module.
iscsi prole-compellant
Congure the auto-detection of Dell Compellent arrays on a port.
Syntax
iscsi profile-compellent
Defaults Dell Compellent disk arrays are not detected.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module.
iscsi target port
Congure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication is monitored.
Syntax
iscsi target port [tcp-port-2...tcp-port-16]ip-address [ip-address]
To remove the congured iSCSI target ports or IP addresses, use the no iscsi target port command.
Parameters
tcp-
port-2...tcpport- 16
Enter the tcp-port number of the iSCSI target ports. The tcp-port-n is the TCP port
number or a list of TCP port numbers on which the iSCSI target listens to requests.
Separate port numbers with a comma. The default is 860, 3260.
870 iSCSI Optimization