Service Manual

Version Description
7.8.1.0 Introduced.
net
To congure an IS-IS network entity title (NET) for a routing process, use this mandatory command. If you did not congure a NET, the IS-
IS process does not start.
Syntax
net network-entity-title
To remove a net, use the no net network-entity-title command.
Parameters
network-entity-title Specify the area address and system ID for an IS-IS routing process. The rst 1 to 13
bytes identify the area address. The next 6 bytes identify the system ID. The last 1 byte is
the selector byte, always identied as zero zero (00). This argument can be applied to an
address or a name.
Defaults Not congured.
Command Modes ROUTER ISIS
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
passive-interface
Suppress routing updates on an interface. This command stops the router from sending updates on that interface.
Syntax
passive-interface interface
To delete a passive interface conguration, use the no passive-interface interface command.
Parameters
interface Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port[/subport] information.
918 Intermediate System to Intermediate System (IS-IS)