Setup Guide
Table Of Contents
- Dell EMC PowerSwitch S4048-ON Installation Guide March 2021
- About this guide
- The S4048–ON switch
- Site preparations
- NEBS compliance
- S4048–ON installation
- Power supplies
- Fans
- Management ports
- Specifications
- Chassis physical design
- IEEE standards
- Agency compliance
- Network Equipment Building Systems Compliance
- USA Federal Communications Commission Statement
- European Union EMC Directive Conformance Statement
- Japan VCCI Compliance for Class A Equipment
- Korean Certification of Compliance
- Safety Standards and Compliance Agency Certifications
- Electromagnetic Compatibility
- Product recycling and disposal
- Technical Support
● Mounting brackets for rack installation, included
● Screws for rack installation
● #1 and #2 Phillips screwdrivers, not included
● Torx screwdriver, not included
● Ground cable screws, included
● Copper/fiber cables
Other optional components are:
● Ground cable
● Additional power supply unit
● Additional fan module
● Additional mounting brackets if installing in a four-post rack or cabinet
S4048–ON configurations
You can order the S4048–ON switch in several different configurations. You can also order optional modules and optics
separately.
You can order the following supported hardware components:
● S4048–ON AC Normal Airflow: 48 port 10 G RJ-45 ports with six QSFP+ 40 G ports, one AC power supply and three fan
subsystems. Airflow is from the I/O-side to the PSU-side.
● S4048–ON AC Reverse Airflow: 48 port 10 G RJ-45 ports with six QSFP+ 40 G ports, one AC power supply and three fan
subsystems. Airflow is from the PSU-side to the I/O-side
● Fan with airflow from the I/O-side to the PSU-side
● Fan with airflow from the PSU-side to the I/O-side
● AC Power supply with airflow from the I/O-side to the PSU-side
● AC Power supply with airflow from the PSU-side to the I/O-side
The S4048–ON switch
11