Setup Guide
Table Of Contents
- Dell EMC PowerSwitch S4048-ON Installation Guide March 2021
- About this guide
- The S4048–ON switch
- Site preparations
- NEBS compliance
- S4048–ON installation
- Power supplies
- Fans
- Management ports
- Specifications
- Chassis physical design
- IEEE standards
- Agency compliance
- Network Equipment Building Systems Compliance
- USA Federal Communications Commission Statement
- European Union EMC Directive Conformance Statement
- Japan VCCI Compliance for Class A Equipment
- Korean Certification of Compliance
- Safety Standards and Compliance Agency Certifications
- Electromagnetic Compatibility
- Product recycling and disposal
- Technical Support
Table 7. Environmental parameters (continued)
Parameter Specifications
Shock Meets Bellcore Zone 4 earthquake requirements (MIL-
STD-810)
Table 8. AC power requirements
Parameter Specifications
Power supply 100–240 VAC 50/60 Hz
Maximum current draw per system
5.8 A @ 398.02 watts/100vac
2.9 A @ 398.02 watts/200vac
Maximum power consumption 460 Watts
Typical power consumption 338 Watts
Reliability MTBF 355.178 hours
IEEE standards
The S4048–ON complies with the following IEEE standards:
● 802.3ab Gigabit Ethernet (1000BASE-T)
● 802.3ae 10 Gigabit Ethernet (10GBASE-X)
● 802.3ba 40 Gigabit Ethernet (40GBase-SR4, 40GBase-CR4) on optical ports
● 802.3u Fast Ethernet (100BASE-TX)
● 802.3z Gigabit Ethernet (1000BASE-X)
Agency compliance
The S4048–ON is designed to comply with the following safety and agency requirements.
Network Equipment Building Systems Compliance
● Use shielded cables for ports from 0 to 48. Ground the shields at both ends.
● Use only reverse airflow configurations in a NEBS-compliant installation.
● Fit the power supplies and fan modules with filter kits. Replace the fan filters on a regular basis.
● Use this equipment with an external, second-level 6 kV lightning surge protective device (SPD) at the AC input of the
building.
● Use an SPD with the AC power connections to protect the AC power supplies from damage from excessive power line
surges.
● In order to comply with the GR-1089 Lightning Criteria for Equipment Interfacing with AC Power Ports, use an SPD at the
AC input of the router.
WARNING:
ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel
ground strap when handling the S4048-ON and its components.
USA Federal Communications Commission Statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
rules. These limits are designated to provide reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and
used in accordance to the instructions, it may cause harmful interference to radio communications. Operation of this equipment
Specifications
37