Administrator Guide

NOTE: After a switch is reloaded, powercycled, or upgraded, the system may display the ACL_AGENT-3-
ISCSI_OPT_MAX_SESS_LIMIT_REACHED: Monitored iSCSI sessions reached maximum limit log
message. This cannot be inferred as the maximum supported iSCSI sessions are reached. Also, number of iSCSI sessions
displayed on the system may show any number equal to or less than the maximum.
The following illustration shows iSCSI optimization between servers and a storage array in which a stack of three switches
connect installed servers (iSCSI initiators) to a storage array (iSCSI targets) in a SAN network. iSCSI optimization running on
the master switch is configured to use dot1p priority-queue assignments to ensure that iSCSI traffic in these sessions receives
priority treatment when forwarded on stacked switch hardware.
Figure 62. iSCSI Optimization Example
Monitoring iSCSI Traffic Flows
The switch snoops iSCSI session-establishment and termination packets by installing classifier rules that trap iSCSI protocol
packets to the CPU for examination.
Devices that initiate iSCSI sessions usually use well-known TCP ports 3260 or 860 to contact targets. When you enable iSCSI
optimization, by default the switch identifies IP packets to or from these ports as iSCSI traffic.
You can configure the switch to monitor traffic for additional port numbers or a combination of port number and target IP
address, and you can remove the well-known port numbers from monitoring.
472
iSCSI Optimization