Administrator Guide

Applying a Class-Map or Input QoS Policy to a Queue
To apply a class-map or input QoS policy to a queue, use the following command.
● Assign an input QoS policy to a queue.
POLICY-MAP-IN mode
service-queue
Applying an Input QoS Policy to an Input Policy Map
To apply an input QoS policy to an input policy map, use the following command.
● Apply an input QoS policy to an input policy map.
POLICY-MAP-IN mode
policy-service-queue <number> qos-polcy
Honoring DSCP Values on Ingress Packets
Dell EMC Networking OS provides the ability to honor DSCP values on ingress packets using Trust DSCP feature.
The following table lists the standard DSCP definitions and indicates to which queues Dell EMC Networking OS maps DSCP
values. When you configure trust DSCP, the matched packets and matched bytes counters are not incremented in the show
qos statistics.
Table 77. Default DSCP to Queue Mapping
DSCP/CP hex range
(XXX)xxx
DSCP Definition Traditional IP
Precedence
Internal Queue ID DSCP/CP decimal
111XXX Network Control 3 48–63
110XXX Internetwork Control 3 48–63
101XXX EF (Expedited
Forwarding)
CRITIC/ECP 2 32–47
100XXX AF4 (Assured
Forwarding)
Flash Override 2 32–47
011XXX AF3 Flash 1 16–31
010XXX AF2 Immediate 1 16–31
001XXX AF1 Priority 0 0–15
000XXX BE (Best Effort) Best Effort 0 0–15
● Enable the trust DSCP feature.
POLICY-MAP-IN mode
trust diffserv
Honoring dot1p Values on Ingress Packets
Dell EMC Networking OS honors dot1p values on ingress packets with the Trust dot1p feature.
The following table specifies the queue to which the classified traffic is sent based on the dot1p value.
Table 78. Default dot1p to Queue Mapping
dot1p Queue ID
0 0
1 0
2 0
748 Quality of Service (QoS)