Administrator Guide

specify a weight to enable a smooth, seamless averaging of packets to handle the sudden overload of packets based on the
previous time sampling performed. You can specify the weight parameter for front-end and backplane ports separately in the
range of 0 through 15.
You can enable WRED and ECN capabilities per queue for granularity. You can disable these functionality per queue, and you can
also specify the minimum and maximum buffer thresholds for each color-coding of the packets. You can configure maximum
drop rate percentage of yellow and green profiles. You can set up these parameters for both front-end and backplane ports.
Global Service Pools With WRED and ECN Settings
Support for global service pools is now available. You can configure global service pools that are shared buffer pools accessed
by multiple queues when the minimum guaranteed buffers for the queue are consumed. Two service pools are used– one for
loss-based queues and the other for lossless (priority-based flow control (PFC)) queues. You can enable WRED and ECN
configuration on the global service-pools.
You can define WRED profiles and weight on each of the global service-pools for both loss-based and lossless (PFC) service-
pools. The following events occur when you configure WRED and ECN on global service-pools:
● If WRED/ECN is enabled on the global service-pool with threshold values and if it is not enabled on the queues, WRED/ECN
are not effective based on global service-pool WRED thresholds. The queue on which the traffic is scheduled must contain
WRED/ECN settings, which are enabled for WRED, to be valid for that traffic.
● When WRED is configured on the global service-pool (regardless of whether ECN on global service-pool is configured), and
one or more queues have WRED enabled and ECN disabled, WRED is effective for the minimum of the thresholds between
the queue threshold and the service-pool threshold.
● When WRED is configured on the global service-pool (regardless of whether ECN on global service-pool is configured), and
one or more queues are enabled with both WRED and ECN, ECN marking takes effect. The packets are ECN marked up to
shared- buffer limits as determined by the shared-ratio for that global service-pool.
WRED/ECN configurations for the queues that belong to backplane ports are common to all the backplane ports and cannot be
specified separately for each backplane port granularity. This behavior occurs to prevent system-level complexities in enabling
this support for backplane ports. Also, WRED/ECN is not supported for multicast packets.
The following table describes the WRED and ECN operations that occur for various scenarios of WRED and ECN configuration
on the queue and service pool. (X denotes not-applicable in the table, 1 indicates that the setting is enabled, 0 represents a
disabled setting. )
Table 80. Scenarios of WRED and ECN Configuration
Queue
Configuration
Service-Pool
Configuration
WRED Threshold
Relationship
Q threshold = Q-T,
Service pool
threshold = SP-T
Expected Functionality
WRED ECN WRED ECN
0 0 X X X WRED/ECN not applicable
1 0 0 X X Queue based WRED,
No ECN marking
1 X Q-T < SP-T
SP-T < Q-T SP based WRED,
No ECN marking
1 1 0 X X Queue-based ECN marking above queue threshold.
ECN marking to shared buffer limits of the service-pool
and then packets are tail dropped.
1 X Q-T < SP-T
SP-T < Q-T Same as above but ECN marking starts above SP-T.
Quality of Service (QoS) 757