Administrator Guide
Related Configuration Tasks
● Configuring the Protocol Type Value for the Outer VLAN Tag
● Configuring Dell EMC Networking OS Options for Trunk Ports
● Debugging VLAN Stacking
● VLAN Stacking in Multi-Vendor Networks
Creating Access and Trunk Ports
To create access and trunk ports, use the following commands.
● Access port — a port on the service provider edge that directly connects to the customer. An access port may belong to
only one service provider VLAN.
● Trunk port — a port on a service provider bridge that connects to another service provider bridge and is a member of
multiple service provider VLANs.
Physical ports and port-channels can be access or trunk ports.
1. Assign the role of access port to a Layer 2 port on a provider bridge that is connected to a customer.
INTERFACE mode
vlan-stack access
2. Assign the role of trunk port to a Layer 2 port on a provider bridge that is connected to another provider bridge.
INTERFACE mode
vlan-stack trunk
3. Assign all access ports and trunk ports to service provider VLANs.
INTERFACE VLAN mode
member
To display the VLAN-Stacking configuration for a switchport, use the show config command from INTERFACE mode.
DellEMC#show run interface tengigabitEthernet 1/1
!
interface TenGigabitEthernet 1/1
no ip address
switchport
vlan-stack access
no shutdown
DellEMC#show run interface tengigabitEthernet 1/2
!
interface TenGigabitEthernet 1/2
no ip address
switchport
vlan-stack trunk
no shutdown
Enable VLAN-Stacking for a VLAN
To enable VLAN-Stacking for a VLAN, use the following command.
● Enable VLAN-Stacking for the VLAN.
INTERFACE VLAN mode
vlan-stack compatible
To display the status and members of a VLAN, use the show vlan command from EXEC Privilege mode. Members of a VLAN-
Stacking-enabled VLAN are marked with an M in column Q.
DellEMC#show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
* 1 Active U Te 3/0-5,18
Service Provider Bridging
855