Administrator Guide

2 2 down UNKNOWN down 0
-- Fan Status --
Unit Bay TrayStatus Fan1 Speed Fan2 Speed
------------------------------------------------------------------------------------
2 1 up up 10031 up 10031
2 2 up up 10031 up 10031
2 3 up up 10134 up 10031
Speed in RPM
-- Unit 3 --
Unit Type : Member Unit
Status : online
Next Boot : online
Required Type : S4048-ON - 54-port TE/FG (SK-ON)
Current Type : S4048-ON - 54-port TE/FG (SK-ON)
Master priority : 5
Hardware Rev : 2.0
Num Ports : 72
Up Time : 33 min, 45 sec
Dell Networking OS Version : 1-0(0-5005)
Jumbo Capable : yes
POE Capable : no
FIPS Mode : disabled
Burned In MAC : 34:17:eb:f2:99:c4
No Of MACs : 3
-- Power Supplies --
Unit Bay Status Type FanStatus FanSpeed(rpm)
---------------------------------------------------------------------------
3 1 up UNKNOWN up 10704
3 2 absent absent 0
-- Fan Status --
Unit Bay TrayStatus Fan1 Speed Fan2 Speed
------------------------------------------------------------------------------------
3 1 up up 10031 up 10031
3 2 up up 9929 up 10031
3 3 up up 10031 up 10134
Speed in RPM
DellEMC#
A change in the stack master occurs when:
● You power down the stack master or bring the master switch offline.
● A failover of the master switch occurs.
● You disconnect the master switch from the stack.
When a stack reloads and all the units come up at the same time; for example, when all units boot up from flash, all units
participate in the election and the master and standby are chosen based on the priority or MAC address.
When the units do not boot up at the same time, such as when some units are powered down just after reloading and powered
up later to join the stack, they do not participate in the election process even though the units that boot up late may have a
higher priority configured. This happens because the master and standby have already been elected, hence the unit that boots
up late joins only as a member.
When an up and running standalone unit or stack is merged with another stack, based on election, the losing stack reloads and
the master unit of the winning stack becomes the master of the merged stack. For more details, see sectionsAdd Units to an
Existing Stack and Remove a Unit from a Stack. It is possible to reset individual units to force them to give up the management
role or reload the whole stack from the CLI to ensure a fully synchronized bootup.
Example of Viewing Stack Members
922
Stacking