Users Guide

2 Member not present
3 Standby online S4810 S4810 8-3-7-13 64
The following example shows removing a stack member (after).
DellEMC#show system brief
Stack MAC : 00:01:e8:8a:df:e6
Reload Type : normal-reload
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
-------------------------------------------------------
0 Management online S4810 S4810 8-3-7-13 64
1 Member not present S4810
2 Member not present
3 Standby online S4810 S4810 8-3-7-13 64
4 Member not present
5 Member not present
6 Member not present
7 Member not present
8 Member not present
9 Member not present
10 Member not present
11 Member not present
NOTE: Each unit in the stack has a stack number that is either assigned by you or Dell EMC Networking OS. To manually
renumber stack members, use the stack-unit old-unit-number renumber new-unit-number command.
Renumbering stack members causes the entire stack to reload.
Removing Front End Port Stacking
To remove the conguration on the front end ports used for stacking, use the following commands.
1 Remove the stack group conguration that is congured.
CONFIGURATION mode
no stack-unit id stack-group id
2 Save the stacking conguration on the ports.
EXEC Privilege mode
write memory
3 Reload the switch.
EXEC Privilege mode
reload
After the units are reloaded, the system reboots. The units come up as standalone units after the reboot completes.
Troubleshoot a Stack
To troubleshoot a stack, use the following recovery tasks.
• Recover from Stack Link Flaps
• Recover from a Card Problem State on a Stack
984
Stacking