Reference Guide

zone default-zone permit
Enables access between all logged-in FC nodes of vfabric in the absence of an active zoneset conguration. A default zone advertises a
maximum of 527 members in the registered state change notication (RSCN) message.
Syntax
zone default-zone permit
Parameters None
Defaults Not congured
Command Mode Vfabric CONFIGURATION
Usage Information
The no version of this command disables access between FC nodes in the absence of an active zoneset.
Example
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# zone default-zone permit
Supported Releases 10.3.1E or later
zoneset activate
Activates an existing zoneset. You can activate only one zoneset in a vfabric.
Syntax
zoneset activate zoneset-name
Parameters zoneset-name — Enter an existing zoneset name.
Defaults Not congured
Command Mode Vfabric CONFIGURATION
Usage Information
The no version of this command deactivates the zoneset. After you disable an active zoneset, the zone
default-zone permit command conguration takes eect. Based on this conguration, the default zone
allows or denies access between all the logged-in FC nodes of the vfabric.
Example
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# zoneset activate set
Supported Releases 10.3.1E or later
116 Fibre channel