Reference Guide

Command Mode IPV6-ACL
Usage Information OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The
no version of this command removes the lter, or use the no seq sequence-number command if you know
the lter’s sequence number.
Example
OS10(config)# ipv6 access-list egress
OS10(conf-ipv6-acl)# seq 5 permit udp any any capture session 1 count
Supported Releases 10.2.0E or later
show access-group
Displays IP, MAC, or IPv6 access-group information.
Syntax
show {ip | mac | ipv6} access-group name
Parameters
• ip — View IP access list information.
• mac — View MAC access group information.
• ipv6 — View IPv6 access group information.
• access-group name — Enter the name of the access group.
Default Not congured
Command Mode EXEC
Usage Information None
Example (IP)
OS10# show ip access-group aaa
Ingress IP access list aaa on ethernet 3/0
Ingress IP access list aaa on ethernet 4/0
Egress IP access list aaa on ethernet 4/0
Example (MAC)
OS10# show mac access-group bbb
Ingress MAC access list aaa on ethernet 3/0
Ingress MAC access list aaa on ethernet 4/0
Egress MAC access list aaa on ethernet 4/0
Example (IPv6)
OS10# show ipv6 access-group ccc
Ingress IPV6 access list aaa on ethernet 3/0
Ingress IPV6 access list aaa on ethernet 4/0
Egress IPV6 access list aaa on ethernet 4/0
Supported Releases 10.2.0E or later
show access-lists
Displays IP, MAC, or IPv6 access-list information.
Syntax
show {ip | mac | ipv6} access-lists {in | out} access-list-name
Parameters
• ip — View IP access list information.
• mac — View MAC access group information.
• ipv6 — View IPv6 access group information.
458 Access Control Lists