Reference Guide
!
interface Ethernet 2/8
no ip address
shutdown
!
interface Ethernet 2/9
no ip address
shutdown
...
View L3 interfaces
OS10# show ip interface brief
Interface IP-Address OK? Method Status Protocol
TenGigabitEthernet 1/1/1 unassigned NO Manual administratively down down
TenGigabitEthernet 1/2/1 unassigned NO Manual administratively down down
TenGigabitEthernet 1/3/1 unassigned YES Manual up up
TenGigabitEthernet 1/4/1 unassigned YES Manual up up
TenGigabitEthernet 1/5/1 unassigned YES Manual up up
TenGigabitEthernet 1/6/1 10.10.10.1 YES Manual up up
TenGigabitEthernet 1/7/1 unassigned NO Manual administratively down down
TenGigabitEthernet 1/8/1 unassigned NO Manual administratively down down
TenGigabitEthernet 1/9/1 unassigned NO Manual administratively down down
View VLAN conguration
OS10(config)# do show vlan
Codes: * - Default VLAN, M - Management VLAN, R - Remote Port Mirroring VLANs
Q: A - Access (Untagged), T - Tagged
NUM Status Description Q Ports
* 1 up A
Eth1/1/5-1/1/8,1/1/27-1/1/28,1/1/31-1/1/54
1002 down
Interface commands
channel-group
Assigns an interface to a port-channel group.
Syntax
channel-group channel-number mode {active | on | passive}
Parameters
• channel-number — Enter a port-channel number (1 to 128).
• mode — Sets the LACP actor mode.
• active — Sets channeling mode to active.
• on — Sets channeling mode to static.
• passive — Sets channeling mode to passive.
Default Not congured
Command Mode INTERFACE
Usage Information The no version of this command resets the value to the default, and unassigns the interface from the port-channel
group.
Example
OS10(config)# interface ethernet 1/1/2:1
OS10(conf-if-eth1/1/2:1)# channel-group 20 mode active
Supported Releases 10.3.0E or later
Interfaces 85