Users Guide

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command
ping
Test connectivity between the system and another device by sending echo requests and waiting for replies.
Syntax
ping [host | ip-address | ipv6-address] [count {number | continuous}]
[datagram-size] [timeout] [source (ip src-ipv4-address) | interface] [tos]
[df-bit (y|n)] [validate-reply(y|n)] [outgoing-interface] [pattern pattern]
[sweep-min-size] [sweep-max-size] [sweep-interval] [ointerface (ip src-
ipv4-address) | interface] [ethernet | vrf vrf-name]
Parameters
host (OPTIONAL) Enter the host name of the devices to which you are testing
connectivity.
ip-address (OPTIONAL) Enter the IPv4 address of the device to which you are testing
connectivity. The address must be in the dotted decimal format.
ipv6-address (OPTIONAL) Enter the IPv6 address, in the x:x:x:x::x format, to which you are
testing connectivity.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
count Enter the number of echo packets to be sent. The default is 5.
● number: from 1 to 2147483647
● continuous: transmit echo request continuously
datagram size Enter the ICMP datagram size. The range is from 36 to 15360 bytes. The default is
100.
timeout Enter the interval to wait for an echo reply before timing out. The range is from 0
to 3600 seconds. The default is 2 seconds.
source Enter the IPv4 or IPv6 source ip address or the source interface. For IPv6
addresses, you may enter global addresses only. Enter the IP address in A.B.C.D
format.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
● For a Tunnel interface, enter the keyword tunnel then a number from 1 to
16383.
120 Control and Monitoring