Users Guide

configured using the ip ssh source-interface command and the ssh
vrf vrf-name command, then an error is reported.
hostname (OPTIONAL) Enter the IP address or the host name of the remote device.
vrf instance (OPTIONAL) E-Series Only: Enter the keyword vrf then the VRF Instance name to
open an SSH connection to that instance.
ipv4 address (OPTIONAL) Enter the IP address in dotted decimal format A.B.C.D.
ipv6-address
prefix-length
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format then the prefix length
in the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
-c encryption
cipher
Enable the “FIPS mode enable", this mode will support the v2 client.
"no fips mode enable"(disable) will support v1 & v2 client. This comment is
applicable for both ciphers & HMAC algorithms:
● 3des-cbc: Force ssh to use 3des-cbc encryption cipher.
● aes128-cbc : Force ssh to use aes128-cbc encryption cipher
● aes192-cbc : Force ssh to use aes192-cbc encryption cipher
● aes256-cbc : Force ssh to use aes256-cbc encryption cipher
● aes128-ctr : Force ssh to use aes128-ctr encryption cipher
● aes192-ctr : Force ssh to use aes192-ctr encryption cipher
● aes256-ctr : Force ssh to use aes256-ctr encryption cipher
-l username (OPTIONAL) Enter the keyword -l then the user name used in this SSH session.
The default is the user name of the user associated with the terminal.
-m HMAC
algorithm
Enter one of the following HMAC algorithms to use:
"no fips mode enable"(disable) will support v1 & v2 client.
● hmac-md5: Force ssh to use hmac-md5 HMAC algorithm.
● hmac-md5-96: Force ssh to use hmac-md5-96 HMAC algorithm.
● hmac-sha1: Force ssh to use hmac-sha1 HMAC algorithm.
● hmac-sha1-96 : Force ssh to use hmac-sha1-96 HMAC algorithm.
● hmac-sha2-256 : Force ssh to use hmac-sha2-256 HMAC algorithm.
-p port-number (OPTIONAL) Enter the keyword -p then the port number. The range is from 1 to
65535. The default is 22.
-v {1 | 2} (OPTIONAL) Enter the keyword -v then the SSH version 1 or 2. The default is the
version from the protocol negotiation.
Defaults As shown in the Parameters section.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Removed the support for hmac-sha2-256-96 algorithm.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
Security 1463