Users Guide

Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810. Added support for source-interface for link-local IPv6
addressing.
8.3.11.1 Introduced on the Z9000.
8.2.1.0 Introduced on the E-Series (IPv6). Increased the number of VLANs to 4094 (was
2094).
8.1.1.0 Introduced on the E-Series (IPv4).
7.9.1.0 Introduced VRF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series and added support for IPv6 address on the E-Series
only.
Usage
Information
The VRF configured using this command has a higher precedence than a VRF configured using the ip
telnet vrf vrf-name command. If you do not use the VRF attribute in this command, then TELENT
client uses the VRF configured using the ip telnet vrf vrf-name command.
The source interface configured using this command has a higher precedence than the source interface
configured using the ip telnet source-interface command. If you do not configure a source
interface using this command, then the TELNET client uses the source interface configured using the ip
telnet source-interface command.
In case there is a mismatch between the VRF telnet source interface and the telnent VRF, then an error is
reported.
Example
DellEMC# telnet vrf vrf1 10.10.10.2
telnet-peer-stack-unit
Open a Telnet connection to the peer stack unit.
Syntax
telnet-peer-stack-unit
Defaults Not configured.
Command Modes
● EXEC
● EXEC Privilege
154 Control and Monitoring