Users Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
When you enable logging synchronous, unsolicited messages appear between software prompts and
outputs. Only the messages with a severity at or below the set level are sent to the console.
If the message queue limit is reached on a terminal line and messages are discarded, a system message
appears on that terminal line. Messages may continue to appear on other terminal lines.
Related
Commands
● logging on — enables logging.
logging trap
Specify which messages are logged to the Syslog server based the message severity.
Syntax
logging trap [level]
To return to the default values, use the default logging trap command.
To disable logging, use the no logging trap command.
Parameters
level Indicate a value from 0 to 7 or enter one of the following parameters:
emergencies, alerts, critical, errors, warnings, notifications,
informational, or debugging. The default is 6 or informational.
Defaults 6 or informational
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
1540 Simple Network Management Protocol (SNMP) and Syslog