Users Guide

Only active routes are eligible for leaking. For example, if one VRF has two routes corresponding to BGP
and OSPF, in which the BGP route is not active, the OSPF route takes precedence over BGP. Even
though the target VRF has specified filtering options to match BGP, the BGP route is not leaked as that
route is not active in the source VRF.
Related
Commands
● ipv6 route-import – imports IPv6 routes from another VRF.
ipv6 route-import
Imports IPv6 routes that another VRF leaks using the tag that VRF specifies during export of these routes.
Syntax
ipv6 route-import tag [route-map-name]
Parameters
route-import Enter the keywords route-import to import IPv6 routes into the VRF.
tag Enter a tag (ASN number) to specify an import route target for importing routes
from another VRF. To import leaked routes from another VRF, use the same ASN
number that is specified as the export route target at the source VRF.
route-map-name Enter the name of the route-map to filter the imported routes.
NOTE: Use the route-map attribute while importing routes from the global
RTM. Route-maps allow you to filter routes at the import end based on the
matching criteria that you define in the route-map.
Defaults N/A
Command Modes
● VRF mode
● CONFIGURATION mode
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON, and Z9500.
Usage
Information
It is possible to configure multiple import conditions per VRF depending on the exporting VRF.
The export-target and import-target support only the match the protocol and prefix-list options. Other
options that you configure in the route-maps are ignored.
Related
Commands
● ipv6 route-export — exports IPv6 routes to another VRF.
match source-protocol
Specify matching source-protocol criteria while exporting or importing routes.
Syntax
match source-protocol {bgp | isis | ospf | connected | static}
Virtual Routing and Forwarding (VRF) 1673