Users Guide

NOTE: This command supports Loopback interfaces EE3 and EF series route processor modules
(RPMs). This command does not support Loopback interfaces ED series RPMs and S-Series
Loopback interfaces.
NOTE: If you apply outbound(egress) IP acl on a switch port, the filter applies only for routed traffic
egressing out of that port.
To associate an access-list to a non-default VRF, use the vrf attribute of this command. You can use
this command at the interface context (physical/LAG) to apply the access-list to a range of VRFs.
The VRF MODE is not available for the default and management VRFs.
In the Dell EMC Networking OS versions prior to 9.13(0.0), the system does not install any of your ACL
rules if the available CAM space is lesser than what is required for your set of ACL rules. Effective with
the Dell EMC Networking OS version 9.13(0.0), the system installs your ACL rules until all the allocated
CAM memory is used. If there is no implicit permit in your rule, the Dell EMC Networking OS ensures that
an implicit deny is installed at the end of your rule. This behavior is applicable for IPv4 and IPv6 ingress
and egress ACLs.
One of the usage scenarios for using the layer3 keyword at the VLAN level, is to avoid ACL being applied
on the L2 traffic which comes in via ICL.
NOTE: The usage scenario listed above is one of many other usage scenarios.
Related
Commands
● ip access-list standard — configure a standard ACL.
● ip access-list extended — configure an extended ACL.
ip mirror-access-group
Assign an IP mirror access control to an interface.
Syntax
ip mirror-access-group access-list-name {in} [implicit-permit] [vlan vlan-
id] [optimized]
To remove an IP mirror-access-group configuration, use the no ip mirror-access-group
access-list-name {in | out} [implicit-permit] [vlan vlan-id] [optimized]
command.
Parameters
access-list-name Enter the name of a configured access list, up to 140 characters.
in Enter the keyword in to apply the ACL to incoming traffic.
implicit-permit (OPTIONAL) Enter the keyword implicit-permit to change the default action
of the ACL from implicit-deny to implicit-permit (that is, if the traffic does not
match the filters in the ACL, the traffic is permitted instead of dropped).
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the ID numbers of the VLANs. The
range is from 1 to 4094 (you can use IDs from 1 to 4094).
optimized (OPTIONAL) Enter the keyword optimized to enable ACL optimization.
Defaults Not enabled.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command-Line Reference Guide.
Version Description
9.11(0.0) Introduced on the S4048–ON, S4048T–ON, S6000, S6000–ON, S6010–ON,
S6100–ON, Z9100–ON, and Z9500.
Related
Commands
● ip access-list standard — configure a standard ACL.
● ip access-list extended — configure an extended ACL.
Access Control Lists (ACL) 191