Users Guide

show ip access-lists
Display all of the IP ACLs configured in the system, whether or not they are applied to an interface, and the count of matches/
mismatches against each ACL entry displayed.
Syntax
show ip access-lists [access-list-name] [interface interface] [in | out]
[vrf vrf-name]
Parameters
access-list-name Enter the name of a configured MAC ACL, up to 140 characters.
interface
interface
Enter the keyword interface followed by the one of the following keywords and
slot/port or number information:
● For a VLAN interface, enter the keyword vlan followed by the slot/port
number.
● For a Port Channel interface, enter the keyword port-channel followed by a
number.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
in | out Identify whether ACL is applied on the ingress or egress side.
vrf vrf-name Enter the keyword vrf and then the name of the VRF to display the access-lists
that are configured on either the default or non-default VRFs.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.5.1.0 Added support for the 4-port 40G line cards on the E-Series.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Standard IP ACL Commands
When you create an ACL without any rule and then apply it to an interface, the ACL behavior reflects an implicit permit.
The platform supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the Commands Common to all ACL Types and Common IP ACL Commands sections.
deny
To drop packets with a certain IP address, configure a filter.
Syntax
deny {source | any | host {ip-address}} [count [bytes] | log] [dscp value]
[ecn value] [fragments] [monitor] [no-drop] [order]
To remove this filter, you have two choices:
194 Access Control Lists (ACL)