Users Guide

Route Map Commands
When you create an access-list without any rule and then applied to an interface, the ACL behavior reflects implicit permit.
To configure route maps and their redistribution criteria, use the following commands.
continue
To a route-map entry with a higher sequence number, configure a route-map.
Syntax
continue [sequence-number]
Parameters
sequence-
number
(OPTIONAL) Enter the route map sequence number. The range is from 1 to 65535.
Defaults Not configured.
Command Modes ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage
Information
The continue feature allows movement from one route-map entry to a specific route-map entry
(the sequence number). If you do not specify the sequence number, the continue feature simply
moves to the next sequence number (also known as an implied continue). If a match clause exists, the
continue feature executes only after a successful match occurs. If there are no successful matches,
the continue feature is ignored.
Match clause with Continue clause
The continue feature can exist without a match clause. A continue clause without a match clause
executes and jumps to the specified route-map entry.
With a match clause and a continue clause, the match clause executes first and the continue clause next
in a specified route map entry. The continue clause launches only after a successful match. The behavior
is:
● A successful match with a continue clause, the route map executes the set clauses and then goes to
the specified route map entry upon execution of the continue clause.
● If the next route map entry contains a continue clause, the route map executes the continue clause if
a successful match occurs.
Access Control Lists (ACL) 243