Users Guide

disable stack-unit phy temp polling
Disable physical temperature polling for 10GBase-T optical ports.
Syntax
disable stack-unit unit-number port port-number phy temp polling
To enable physical temperature polling, use the enable stack-unit unit-number port port-
number phy temp polling command.
Parameters
stack-unit unit-
number
Enter the keyword stack-unit then the unit-numberfor which you want to
disable temperature polling. The range is from 1 to 6.
port port-number Enter the keyword port then the port-number for which you want to disable
temperature polling. The range is from 1 to 48.
Defaults Enabled
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced on the S4048–ON and S5048F-ON.
Usage
Information
This feature is applicable only for 10GBase-T optical ports.
NOTE: It is not supported for stacking ports.
enable stack-unit phy temp polling
Enable physical temperature polling for 10GBase-T optical ports.
Syntax
enable stack-unit unit-number port port-number phy temp polling
To disable physical temperature polling, use the disable stack-unit unit-number port port-
number phy temp polling command.
Parameters
stack-unit unit-
number
Enter the keyword stack-unit then the unit-number for which you want to
enable temperature polling. The range is from 1 to 6.
port port-number Enter the keyword port then the port-number for which you want to enable
temperature polling. The range is from 1 to 48.
Defaults Enabled
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced on the S4048–ON and S5048F-ON.
Usage
Information
This feature is applicable only for 10GBase-T optical ports.
NOTE: It is not supported for stacking ports.
678 Interfaces