Users Guide

multiplier
Set the multiple of the hello timer before LLDP declares the interface dead.
Syntax
multiplier number
To return to the default, use the no multiplier command.
Parameters
integer Enter the number of consecutive misses before the LLDP declares the interface
dead. The range is from 2 to 10.
Defaults 4
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
protocol lldp (Configuration)
Enable the LLDP globally on the switch.
Syntax
protocol lldp
To disable LLDP globally on the chassis, use the no protocol lldp command.
Defaults Enabled.
Command Modes CONFIGURATION (conf-lldp)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Link Layer Discovery Protocol (LLDP) 983